Fire-Resistant Glass
Integrity and insulating fire glass supplied and fitted into tested frames.
Learn more →Fire glass replacement in Totton is usually needed for one of three reasons: new building work, a change to an existing fire-resisting wall, or defects found in an inspection. We handle all three.
Tell us what you need. We reply with next steps and a guide price.
Broken fire glass replacement is the repair of cracked, shattered or damaged fire-resistant panes with glass of a type the frame's evidence allows, refitted with the correct beads and seals. A cracked fire pane may not perform as tested, so it should be made safe and replaced promptly.
A broken pane can be a cut hazard and a gap in compartmentation. We can make it safe on the first visit while the replacement is cut.
Repeated breakage can point to frame movement, door slamming or impact from trolleys. We look at the cause.
When the original glass is no longer available, the replacement must be covered by the frame's evidence or an assessment.
Coverage around Totton includes the SO40, SO16, SO15 districts and nearby Southampton, Hythe, Eastleigh. Totton is about 6 km from Southampton, the largest town in our Hampshire coverage.
Every quote in Totton identifies the tested system: frame, glass, beads, seals and fixings, within its pane-size limits.
After survey you get a fixed written quote for the agreed scope, so Totton budgets are not open-ended.
We can phase work in Totton around residents, staff or pupils, with out-of-hours options.
Building work in England is covered by the Building Regulations 2010, with fire safety guidance in Approved Document B and impact safety guidance for glazing in Approved Document K.
Once a building is in use, the Regulatory Reform (Fire Safety) Order 2005 requires the responsible person to maintain fire safety measures, including fire-resisting glazing. The Fire Safety (England) Regulations 2022 add duties for multi-occupied residential buildings, including fire door checks in buildings over 11 metres.
Sector guides below cover hotels, retail and leisure units and other buildings in Totton.
Lead times depend on the glass. Integrity glass is often quick to supply; insulating glass is made to size.
Look for an etched or printed mark in a corner of the pane. Send us a photo with the approximate size.
Building work in Totton follows the Building Regulations 2010 and Approved Document B, and occupied buildings are covered by the Regulatory Reform (Fire Safety) Order 2005.
We can give a guide range from photos and sizes, including a clear photo of any marks on the glass. A fixed price follows a survey.
Integrity and insulating fire glass supplied and fitted into tested frames.
Learn more →Replacement and new vision panels fitted to the door's evidence.
Learn more →Putting right the defects found in surveys and fire risk assessments.
Learn more →EI 30 to EI 120 glass that blocks heat as well as flames.
Learn more →Tell us the rating required, sizes and building type, or ask us to find out.
We measure each opening in Totton and check what the existing frames can accept.
You receive a written quote naming the tested system and classification.
Installation to the system details, then a handover pack with photographs and evidence.
Send sizes, photos of any glass marks or your inspection report and we will come back with the right tested system.