Fire-Resistant Glass
Integrity and insulating fire glass supplied and fitted into tested frames.
Learn more →Looking for insulated fire glass in Bognor Regis? We survey, supply and install tested fire-rated glazing for industrial units, blocks of flats and other buildings in and around Bognor Regis, including the PO21 postcode district.
Tell us what you need. We reply with next steps and a guide price.
EI glass is the choice where people need to pass close to the glass during a fire, where combustible materials sit near it, or where building guidance would otherwise restrict glazing. We supply and fit EI 30 to EI 120 glass in tested frames, internally and externally.
When heated, the interlayers turn opaque and expand, forming an insulating shield. After a fire the glass will need replacing.
Insulating fire glass should be stored dry, upright and away from direct sun before fitting.
Modern EI glass is clear in normal use, with high light transmission at lower ratings.
Building work in England is covered by the Building Regulations 2010, with fire safety guidance in Approved Document B and impact safety guidance for glazing in Approved Document K.
Once a building is in use, the Regulatory Reform (Fire Safety) Order 2005 requires the responsible person to maintain fire safety measures, including fire-resisting glazing. The Fire Safety (England) Regulations 2022 add duties for multi-occupied residential buildings, including fire door checks in buildings over 11 metres.
In higher-risk buildings, broadly 18 metres or seven storeys with two or more homes, the Building Safety Regulator is the building control authority. England is also phasing out BS 476 references from Approved Document B, with the remaining fire-resistance references due to go in September 2029.
Whether the building is in central Bognor Regis or the wider PO21, PO22 districts, we can survey and quote. We also cover Chichester, Littlehampton, Worthing. Crawley, around 51 km from Bognor Regis, is the largest town in the same coverage area.
Every quote in Bognor Regis identifies the tested system: frame, glass, beads, seals and fixings, within its pane-size limits.
If an existing frame in a Bognor Regis building has no traceable evidence, we say so and price the options rather than guess.
You receive the classification references, glass marks and installation photographs for your fire safety records.
We can survey and quote for industrial units, blocks of flats and other building types in Bognor Regis.
Yes. Once the interlayers have reacted, the glass has done its job and must be replaced.
Only products approved for external use, usually in a sealed unit with UV protection.
Survey timing in Bognor Regis depends on access, the size of the building and how urgent the defect is. Tell us your deadline when you enquire and we will confirm a date before you commit.
Yes. We survey and install in Bognor Regis and across West Sussex, including the PO21 district and nearby Chichester.
Integrity and insulating fire glass supplied and fitted into tested frames.
Learn more →E and EW glass where flames and hot gases must be stopped.
Learn more →Glazed screens and doors on protected stairs, lobbies and corridors.
Learn more →Butt-jointed fire glass walls with minimal frames.
Learn more →Send the fire strategy extract, inspection report or a few photos of the openings.
We measure each opening in Bognor Regis and check what the existing frames can accept.
We set out the system, glass, evidence and programme, with a fixed price.
We install, photograph seals and fixings before closing up, and hand over the schedule.
Send sizes, photos of any glass marks or your inspection report and we will come back with the right tested system.