Frameless Fire-Rated Glazing
Butt-jointed fire glass walls with minimal frames.
Learn more →Fire-rated glass partitions in Barnes is usually needed for one of three reasons: new building work, a change to an existing fire-resisting wall, or defects found in an inspection. We handle all three.
Tell us what you need. We reply with next steps and a guide price.
Office fit-outs often only need fire-rated glazing on certain lines, such as corridors that serve as escape routes. We work from your fire strategy to rate only what needs rating, and match the look across the rest of the floor so the design stays consistent.
Meeting rooms often need acoustic performance too. Some fire partition systems are tested for both; we confirm the combination.
Large glass walls need manifestation so people can see them. Applied film must be compatible with the glass and not cover any marks building control may need to see.
A fire-rated partition is only as good as the construction above it. If the wall has to run to the slab, the ceiling void needs fire-stopping or a rated head detail.
Building work in England is covered by the Building Regulations 2010, with fire safety guidance in Approved Document B and impact safety guidance for glazing in Approved Document K.
Once a building is in use, the Regulatory Reform (Fire Safety) Order 2005 requires the responsible person to maintain fire safety measures, including fire-resisting glazing. The Fire Safety (England) Regulations 2022 add duties for multi-occupied residential buildings, including fire door checks in buildings over 11 metres.
We cover Barnes and the surrounding postcode districts, including SW13, SW14, W4, SW15, W6, W14. Nearby towns we also serve include Chiswick, Putney, Fulham. Barnes sits within our Greater London coverage, alongside Chiswick.
After survey you get a fixed written quote for the agreed scope, so Barnes budgets are not open-ended.
If an existing frame in a Barnes building has no traceable evidence, we say so and price the options rather than guess.
We can phase work in Barnes around residents, staff or pupils, with out-of-hours options.
We can survey and quote for blocks of flats, offices and other building types in Barnes.
Frames may be slightly deeper and glass slightly thicker, but most systems are hard to tell apart from standard partitions.
Yes. We can supply and install the rated glazing package within a wider fit-out, working to your programme.
Building work in Barnes follows the Building Regulations 2010 and Approved Document B, and occupied buildings are covered by the Regulatory Reform (Fire Safety) Order 2005.
Yes. We plan phasing, out-of-hours work and temporary protection so the building can stay in use where the fire strategy allows.
Butt-jointed fire glass walls with minimal frames.
Learn more →Light, modern aluminium framing tested for fire.
Learn more →Doorsets with large glazed panels, tested as complete units.
Learn more →Internal glazed screens that keep compartments and corridors protected.
Learn more →Send drawings, a fire risk assessment action or photos of the glass marks.
We measure each opening in Barnes and check what the existing frames can accept.
You receive a written quote naming the tested system and classification.
Installation to the system details, then a handover pack with photographs and evidence.
Send sizes, photos of any glass marks or your inspection report and we will come back with the right tested system.