Fire-Rated Glass Partitions
Office glass partitions where the wall has to be fire-resisting.
Learn more →Our frameless fire-rated glazing service covers Burton upon Trent and neighbouring areas such as Swadlincote and Derby, with every job built around a tested system.
Tell us what you need. We reply with next steps and a guide price.
Frameless fire glazing only works within tight, tested limits: specific glass types, joint widths, sealants, channel details and maximum heights. We specify it where the evidence supports your layout, and tell you plainly when a slim framed system is the better route.
Survey visits can be arranged anywhere in Burton upon Trent, including the DE14, DE15, DE13 districts, and in nearby Swadlincote, Derby, Lichfield. Stoke-on-Trent, around 42 km from Burton upon Trent, is the largest town in the same coverage area.
The sealant, joint width and any interlayer in the joint come from the test. Generic silicone in a fire glass joint is not acceptable.
Frameless glass is exposed during the build. We plan protection until other trades finish.
Channels at the head have to allow for slab movement without loading the glass.
Building work in England is covered by the Building Regulations 2010, with fire safety guidance in Approved Document B and impact safety guidance for glazing in Approved Document K.
Once a building is in use, the Regulatory Reform (Fire Safety) Order 2005 requires the responsible person to maintain fire safety measures, including fire-resisting glazing. The Fire Safety (England) Regulations 2022 add duties for multi-occupied residential buildings, including fire door checks in buildings over 11 metres.
In higher-risk buildings, broadly 18 metres or seven storeys with two or more homes, the Building Safety Regulator is the building control authority. England is also phasing out BS 476 references from Approved Document B, with the remaining fire-resistance references due to go in September 2029.
Every quote in Burton upon Trent identifies the tested system: frame, glass, beads, seals and fixings, within its pane-size limits.
After survey you get a fixed written quote for the agreed scope, so Burton upon Trent budgets are not open-ended.
If an existing frame in a Burton upon Trent building has no traceable evidence, we say so and price the options rather than guess.
Frameless fire-rated glazing applies to many building types in Burton upon Trent, including care homes and healthcare buildings.
Yes, using tested butt-jointed systems, usually with insulating glass. It must be installed exactly to the tested details.
Usually through a slim framed door set into the run, chosen so the combination is covered by evidence.
Building work in Burton upon Trent follows the Building Regulations 2010 and Approved Document B, and occupied buildings are covered by the Regulatory Reform (Fire Safety) Order 2005.
We can give a guide range from photos and sizes, including a clear photo of any marks on the glass. A fixed price follows a survey.
Office glass partitions where the wall has to be fire-resisting.
Learn more →EI 30 to EI 120 glass that blocks heat as well as flames.
Learn more →Internal glazed screens that keep compartments and corridors protected.
Learn more →Doorsets with large glazed panels, tested as complete units.
Learn more →Send drawings, a fire risk assessment action or photos of the glass marks.
We measure each opening in Burton upon Trent and check what the existing frames can accept.
You receive a written quote naming the tested system and classification.
We install, photograph seals and fixings before closing up, and hand over the schedule.
Send sizes, photos of any glass marks or your inspection report and we will come back with the right tested system.