Fire-Rated Glass Partitions
Office glass partitions where the wall has to be fire-resisting.
Learn more →Looking for frameless fire-rated glazing in Pontypridd? We survey, supply and install tested fire-rated glazing for retail and leisure units, offices and other buildings in and around Pontypridd, including the CF37 postcode district.
Tell us what you need. We reply with next steps and a guide price.
Frameless fire glazing only works within tight, tested limits: specific glass types, joint widths, sealants, channel details and maximum heights. We specify it where the evidence supports your layout, and tell you plainly when a slim framed system is the better route.
After survey you get a fixed written quote for the agreed scope, so Pontypridd budgets are not open-ended.
If an existing frame in a Pontypridd building has no traceable evidence, we say so and price the options rather than guess.
Every quote in Pontypridd identifies the tested system: frame, glass, beads, seals and fixings, within its pane-size limits.
The sealant, joint width and any interlayer in the joint come from the test. Generic silicone in a fire glass joint is not acceptable.
Maximum heights and the ability to form corners vary by system. Corners may need a post or a specific tested joint.
True frameless fire doors are rare; most frameless walls use a slim framed door within the run. We show you the options on drawings.
Whether the building is in central Pontypridd or the wider CF37 districts, we can survey and quote. We also cover Tonypandy, Caerphilly, Rhondda. Rhondda, around 10 km from Pontypridd, is the largest town in the same coverage area.
Building regulations are devolved in Wales, so fire safety design follows the Welsh Ministers' version of Approved Document B rather than the English one, alongside impact safety guidance for glazing.
The Regulatory Reform (Fire Safety) Order 2005 applies in Wales, so the responsible person must maintain fire-resisting glazing as part of the premises' fire safety measures. The Fire Safety Act 2021 confirmed this extends to the structure, external walls and flat entrance doors of multi-occupied residential buildings.
Wales is introducing its own building safety regime for occupied residential buildings, so check current Welsh requirements before planning major works to blocks of flats.
Sector guides below cover retail and leisure units, offices and other buildings in Pontypridd.
Each system states a maximum height. We check your floor-to-ceiling height against it during design.
Yes, using tested butt-jointed systems, usually with insulating glass. It must be installed exactly to the tested details.
Pontypridd is in Wales, where the Welsh Approved Document B applies to building work and the Regulatory Reform (Fire Safety) Order 2005 covers occupied premises.
Yes. We survey and install in Pontypridd and across Mid Glamorgan, including the CF37 district and nearby Tonypandy.
Office glass partitions where the wall has to be fire-resisting.
Learn more →EI 30 to EI 120 glass that blocks heat as well as flames.
Learn more →Internal glazed screens that keep compartments and corridors protected.
Learn more →Doorsets with large glazed panels, tested as complete units.
Learn more →Send the fire strategy extract, inspection report or a few photos of the openings.
We measure each opening in Pontypridd and check what the existing frames can accept.
We set out the system, glass, evidence and programme, with a fixed price.
Installation to the system details, then a handover pack with photographs and evidence.
Send sizes, photos of any glass marks or your inspection report and we will come back with the right tested system.