Fire-Rated Glass Partitions
Office glass partitions where the wall has to be fire-resisting.
Learn more →Frameless fire-rated glazing in Gloucester is usually needed for one of three reasons: new building work, a change to an existing fire-resisting wall, or defects found in an inspection. We handle all three.
Tell us what you need. We reply with next steps and a guide price.
Frameless fire glazing only works within tight, tested limits: specific glass types, joint widths, sealants, channel details and maximum heights. We specify it where the evidence supports your layout, and tell you plainly when a slim framed system is the better route.
Whether the building is in central Gloucester or the wider GL1, GL2 districts, we can survey and quote. We also cover Cheltenham, Stroud, Tewkesbury. Gloucester is the largest town in our Gloucestershire coverage.
The sealant, joint width and any interlayer in the joint come from the test. Generic silicone in a fire glass joint is not acceptable.
True frameless fire doors are rare; most frameless walls use a slim framed door within the run. We show you the options on drawings.
Frameless glass is exposed during the build. We plan protection until other trades finish.
Building work in England is covered by the Building Regulations 2010, with fire safety guidance in Approved Document B and impact safety guidance for glazing in Approved Document K.
Once a building is in use, the Regulatory Reform (Fire Safety) Order 2005 requires the responsible person to maintain fire safety measures, including fire-resisting glazing. The Fire Safety (England) Regulations 2022 add duties for multi-occupied residential buildings, including fire door checks in buildings over 11 metres.
In higher-risk buildings, broadly 18 metres or seven storeys with two or more homes, the Building Safety Regulator is the building control authority. England is also phasing out BS 476 references from Approved Document B, with the remaining fire-resistance references due to go in September 2029.
After survey you get a fixed written quote for the agreed scope, so Gloucester budgets are not open-ended.
If an existing frame in a Gloucester building has no traceable evidence, we say so and price the options rather than guess.
We can phase work in Gloucester around residents, staff or pupils, with out-of-hours options.
Sector guides below cover retail and leisure units, healthcare buildings and other buildings in Gloucester.
Each system states a maximum height. We check your floor-to-ceiling height against it during design.
Usually through a slim framed door set into the run, chosen so the combination is covered by evidence.
We can give a guide range from photos and sizes, including a clear photo of any marks on the glass. A fixed price follows a survey.
Yes. We survey and install in Gloucester and across Gloucestershire, including the GL1 district and nearby Cheltenham.
Office glass partitions where the wall has to be fire-resisting.
Learn more →EI 30 to EI 120 glass that blocks heat as well as flames.
Learn more →Internal glazed screens that keep compartments and corridors protected.
Learn more →Doorsets with large glazed panels, tested as complete units.
Learn more →Send the fire strategy extract, inspection report or a few photos of the openings.
We visit Gloucester to measure, record existing marks and check the frames and substrate.
Your quote lists each item with its classification and the evidence it relies on.
Work is completed to the manufacturer's details and documented for your records.
Send sizes, photos of any glass marks or your inspection report and we will come back with the right tested system.