Fire-Resistant Glass
Integrity and insulating fire glass supplied and fitted into tested frames.
Learn more →If a building in Hertford needs integrity fire glass, the starting point is the rating its fire strategy requires. We confirm that, survey the openings and quote a tested system to suit.
Tell us what you need. We reply with next steps and a guide price.
We supply and fit integrity glass in screens, doors, vision panels and windows where the fire strategy allows it, and upgrade to EW or EI where it does not. Choosing correctly between E, EW and EI is where most of the cost on a project is decided.
Modern integrity glass is usually available with an impact classification, unlike plain wired glass.
Integrity-only glass may be acceptable in some fire-resisting partitions, screens and doors, often at high level, within the limits national guidance sets. Compartment walls normally need insulating (EI) glazing.
Building guidance restricts how much integrity-only glass can be used on protected escape routes and where it can sit. Check the route before choosing E glass.
Building work in England is covered by the Building Regulations 2010, with fire safety guidance in Approved Document B and impact safety guidance for glazing in Approved Document K.
Once a building is in use, the Regulatory Reform (Fire Safety) Order 2005 requires the responsible person to maintain fire safety measures, including fire-resisting glazing. The Fire Safety (England) Regulations 2022 add duties for multi-occupied residential buildings, including fire door checks in buildings over 11 metres.
In higher-risk buildings, broadly 18 metres or seven storeys with two or more homes, the Building Safety Regulator is the building control authority. England is also phasing out BS 476 references from Approved Document B, with the remaining fire-resistance references due to go in September 2029.
Whether the building is in central Hertford or the wider SG13, SG14 districts, we can survey and quote. We also cover Hoddesdon, Welwyn Garden City, Hatfield. Hertford lies roughly 27 km from Watford, within our Hertfordshire coverage.
If an existing frame in a Hertford building has no traceable evidence, we say so and price the options rather than guess.
Every quote in Hertford identifies the tested system: frame, glass, beads, seals and fixings, within its pane-size limits.
After survey you get a fixed written quote for the agreed scope, so Hertford budgets are not open-ended.
Sector guides below cover schools and colleges, retail and leisure units and other buildings in Hertford.
Glass that stops flames and hot gases for the rated time but lets heat through. It is classified E.
Yes, considerably, and it is thinner and lighter.
Building work in Hertford follows the Building Regulations 2010 and Approved Document B, and occupied buildings are covered by the Regulatory Reform (Fire Safety) Order 2005.
Yes. We survey and install in Hertford and across Hertfordshire, including the SG13 district and nearby Hoddesdon.
Integrity and insulating fire glass supplied and fitted into tested frames.
Learn more →EI 30 to EI 120 glass that blocks heat as well as flames.
Learn more →Replace old Georgian wired glass with modern fire glass.
Learn more →Replacement and new vision panels fitted to the door's evidence.
Learn more →Send drawings, a fire risk assessment action or photos of the glass marks.
A survey in Hertford confirms sizes, access, existing evidence and fixing conditions.
We set out the system, glass, evidence and programme, with a fixed price.
We install, photograph seals and fixings before closing up, and hand over the schedule.
Send sizes, photos of any glass marks or your inspection report and we will come back with the right tested system.