Fire-Resistant Glass
Integrity and insulating fire glass supplied and fitted into tested frames.
Learn more →For Dunstable buildings, we supply, replace and check integrity fire glass wherever the fire strategy depends on it, working to the tested system rather than the glass alone.
Tell us what you need. We reply with next steps and a guide price.
Integrity fire glass, classified E, stops flames and hot gases passing for the rated time but does not limit the heat coming through. EW glass adds a cap on the heat radiated through the glass. Both are thinner, lighter and cheaper than fully insulated glass.
Modern integrity glass is usually available with an impact classification, unlike plain wired glass.
E glass gets hot in a fire. Furniture or stored materials beside it can ignite from radiated heat.
Building guidance restricts how much integrity-only glass can be used on protected escape routes and where it can sit. Check the route before choosing E glass.
Building work in England is covered by the Building Regulations 2010, with fire safety guidance in Approved Document B and impact safety guidance for glazing in Approved Document K.
Once a building is in use, the Regulatory Reform (Fire Safety) Order 2005 requires the responsible person to maintain fire safety measures, including fire-resisting glazing. The Fire Safety (England) Regulations 2022 add duties for multi-occupied residential buildings, including fire door checks in buildings over 11 metres.
Our Bedfordshire coverage takes in Dunstable (LU6, LU4) and the neighbouring towns of Luton, Leighton Buzzard, Harpenden. Dunstable is about 7 km from Luton, the largest town in our Bedfordshire coverage.
We can phase work in Dunstable around residents, staff or pupils, with out-of-hours options.
You receive the classification references, glass marks and installation photographs for your fire safety records.
If an existing frame in a Dunstable building has no traceable evidence, we say so and price the options rather than guess.
Sector guides below cover care homes, retail and leisure units and other buildings in Dunstable.
In limited amounts and positions. Building guidance sets the rules; insulating glass is used where those limits are exceeded.
Yes, considerably, and it is thinner and lighter.
Building work in Dunstable follows the Building Regulations 2010 and Approved Document B, and occupied buildings are covered by the Regulatory Reform (Fire Safety) Order 2005.
Yes. We survey and install in Dunstable and across Bedfordshire, including the LU6 district and nearby Luton.
Integrity and insulating fire glass supplied and fitted into tested frames.
Learn more →EI 30 to EI 120 glass that blocks heat as well as flames.
Learn more →Replace old Georgian wired glass with modern fire glass.
Learn more →Replacement and new vision panels fitted to the door's evidence.
Learn more →Tell us the rating required, sizes and building type, or ask us to find out.
We visit Dunstable to measure, record existing marks and check the frames and substrate.
You receive a written quote naming the tested system and classification.
We install, photograph seals and fixings before closing up, and hand over the schedule.
Send sizes, photos of any glass marks or your inspection report and we will come back with the right tested system.