Frameless Fire-Rated Glazing
Butt-jointed fire glass walls with minimal frames.
Learn more →Our fire-rated glass partitions service covers Grimsby and neighbouring areas such as Cleethorpes and Kingston upon Hull, with every job built around a tested system.
Tell us what you need. We reply with next steps and a guide price.
Office fit-outs often only need fire-rated glazing on certain lines, such as corridors that serve as escape routes. We work from your fire strategy to rate only what needs rating, and match the look across the rest of the floor so the design stays consistent.
Our Lincolnshire coverage takes in Grimsby (DN32, DN31, DN34, DN35, DN33) and the neighbouring towns of Cleethorpes, Kingston upon Hull, Scunthorpe. Grimsby lies roughly 49 km from Lincoln, within our Lincolnshire coverage.
Rated partitions need fire-stopping inspected before ceilings close. We plan inspection points into the fit-out programme.
Non-rated partitions on the same floor can be matched in profile and finish.
Large glass walls need manifestation so people can see them. Applied film must be compatible with the glass and not cover any marks building control may need to see.
Building work in England is covered by the Building Regulations 2010, with fire safety guidance in Approved Document B and impact safety guidance for glazing in Approved Document K.
Once a building is in use, the Regulatory Reform (Fire Safety) Order 2005 requires the responsible person to maintain fire safety measures, including fire-resisting glazing. The Fire Safety (England) Regulations 2022 add duties for multi-occupied residential buildings, including fire door checks in buildings over 11 metres.
In higher-risk buildings, broadly 18 metres or seven storeys with two or more homes, the Building Safety Regulator is the building control authority. England is also phasing out BS 476 references from Approved Document B, with the remaining fire-resistance references due to go in September 2029.
You receive the classification references, glass marks and installation photographs for your fire safety records.
Every quote in Grimsby identifies the tested system: frame, glass, beads, seals and fixings, within its pane-size limits.
After survey you get a fixed written quote for the agreed scope, so Grimsby budgets are not open-ended.
Sector guides below cover blocks of flats, retail and leisure units and other buildings in Grimsby.
Some butt-jointed systems are tested for fire. See our frameless fire-rated glazing service for what is possible.
Frames may be slightly deeper and glass slightly thicker, but most systems are hard to tell apart from standard partitions.
We can give a guide range from photos and sizes, including a clear photo of any marks on the glass. A fixed price follows a survey.
Building work in Grimsby follows the Building Regulations 2010 and Approved Document B, and occupied buildings are covered by the Regulatory Reform (Fire Safety) Order 2005.
Butt-jointed fire glass walls with minimal frames.
Learn more →Light, modern aluminium framing tested for fire.
Learn more →Doorsets with large glazed panels, tested as complete units.
Learn more →Internal glazed screens that keep compartments and corridors protected.
Learn more →Tell us the rating required, sizes and building type, or ask us to find out.
We measure each opening in Grimsby and check what the existing frames can accept.
We set out the system, glass, evidence and programme, with a fixed price.
Installation to the system details, then a handover pack with photographs and evidence.
Send sizes, photos of any glass marks or your inspection report and we will come back with the right tested system.