Fire-Rated Glass Partitions
Office glass partitions where the wall has to be fire-resisting.
Learn more →From the OX11 district outwards, we arrange frameless fire-rated glazing for buildings across Didcot, matching glass, frames and seals to tested evidence rather than guesswork.
Tell us what you need. We reply with next steps and a guide price.
Frameless fire glazing only works within tight, tested limits: specific glass types, joint widths, sealants, channel details and maximum heights. We specify it where the evidence supports your layout, and tell you plainly when a slim framed system is the better route.
After survey you get a fixed written quote for the agreed scope, so Didcot budgets are not open-ended.
If an existing frame in a Didcot building has no traceable evidence, we say so and price the options rather than guess.
Every quote in Didcot identifies the tested system: frame, glass, beads, seals and fixings, within its pane-size limits.
Frameless glass is exposed during the build. We plan protection until other trades finish.
True frameless fire doors are rare; most frameless walls use a slim framed door within the run. We show you the options on drawings.
The sealant, joint width and any interlayer in the joint come from the test. Generic silicone in a fire glass joint is not acceptable.
Whether the building is in central Didcot or the wider OX11, OX14 districts, we can survey and quote. We also cover Abingdon, Oxford, Thatcham. Didcot is about 16 km from Oxford, the largest town in our Oxfordshire coverage.
Building work in England is covered by the Building Regulations 2010, with fire safety guidance in Approved Document B and impact safety guidance for glazing in Approved Document K.
Once a building is in use, the Regulatory Reform (Fire Safety) Order 2005 requires the responsible person to maintain fire safety measures, including fire-resisting glazing. The Fire Safety (England) Regulations 2022 add duties for multi-occupied residential buildings, including fire door checks in buildings over 11 metres.
In higher-risk buildings, broadly 18 metres or seven storeys with two or more homes, the Building Safety Regulator is the building control authority. England is also phasing out BS 476 references from Approved Document B, with the remaining fire-resistance references due to go in September 2029.
We can survey and quote for blocks of flats, retail and leisure units and other building types in Didcot.
Usually through a slim framed door set into the run, chosen so the combination is covered by evidence.
Yes, using tested butt-jointed systems, usually with insulating glass. It must be installed exactly to the tested details.
Survey timing in Didcot depends on access, the size of the building and how urgent the defect is. Tell us your deadline when you enquire and we will confirm a date before you commit.
We can give a guide range from photos and sizes, including a clear photo of any marks on the glass. A fixed price follows a survey.
Office glass partitions where the wall has to be fire-resisting.
Learn more →EI 30 to EI 120 glass that blocks heat as well as flames.
Learn more →Internal glazed screens that keep compartments and corridors protected.
Learn more →Doorsets with large glazed panels, tested as complete units.
Learn more →Send drawings, a fire risk assessment action or photos of the glass marks.
We visit Didcot to measure, record existing marks and check the frames and substrate.
We set out the system, glass, evidence and programme, with a fixed price.
Installation to the system details, then a handover pack with photographs and evidence.
Send sizes, photos of any glass marks or your inspection report and we will come back with the right tested system.