Fire-Rated Glass Partitions
Office glass partitions where the wall has to be fire-resisting.
Learn more →Looking for frameless fire-rated glazing in Skelmersdale? We survey, supply and install tested fire-rated glazing for blocks of flats, retail and leisure units and other buildings in and around Skelmersdale, including the WN8 postcode district.
Tell us what you need. We reply with next steps and a guide price.
Frameless fire-rated glazing is a glass wall where panes meet edge to edge with a tested sealant joint instead of vertical frames, held in discreet head and base channels. It gives an almost uninterrupted view while still being tested to resist fire.
Frameless glass is exposed during the build. We plan protection until other trades finish.
Channels at the head have to allow for slab movement without loading the glass.
The sealant, joint width and any interlayer in the joint come from the test. Generic silicone in a fire glass joint is not acceptable.
Building work in England is covered by the Building Regulations 2010, with fire safety guidance in Approved Document B and impact safety guidance for glazing in Approved Document K.
Once a building is in use, the Regulatory Reform (Fire Safety) Order 2005 requires the responsible person to maintain fire safety measures, including fire-resisting glazing. The Fire Safety (England) Regulations 2022 add duties for multi-occupied residential buildings, including fire door checks in buildings over 11 metres.
In higher-risk buildings, broadly 18 metres or seven storeys with two or more homes, the Building Safety Regulator is the building control authority. England is also phasing out BS 476 references from Approved Document B, with the remaining fire-resistance references due to go in September 2029.
Our Lancashire coverage takes in Skelmersdale (WN8) and the neighbouring towns of Ormskirk, Wigan, Kirkby. Skelmersdale is about 24 km from Preston, the largest town in our Lancashire coverage.
After survey you get a fixed written quote for the agreed scope, so Skelmersdale budgets are not open-ended.
Every quote in Skelmersdale identifies the tested system: frame, glass, beads, seals and fixings, within its pane-size limits.
If an existing frame in a Skelmersdale building has no traceable evidence, we say so and price the options rather than guess.
Sector guides below cover blocks of flats, retail and leisure units and other buildings in Skelmersdale.
Yes, using tested butt-jointed systems, usually with insulating glass. It must be installed exactly to the tested details.
Each system states a maximum height. We check your floor-to-ceiling height against it during design.
Yes. We plan phasing, out-of-hours work and temporary protection so the building can stay in use where the fire strategy allows.
We can give a guide range from photos and sizes, including a clear photo of any marks on the glass. A fixed price follows a survey.
Office glass partitions where the wall has to be fire-resisting.
Learn more →EI 30 to EI 120 glass that blocks heat as well as flames.
Learn more →Internal glazed screens that keep compartments and corridors protected.
Learn more →Doorsets with large glazed panels, tested as complete units.
Learn more →Tell us the rating required, sizes and building type, or ask us to find out.
A survey in Skelmersdale confirms sizes, access, existing evidence and fixing conditions.
We set out the system, glass, evidence and programme, with a fixed price.
We install, photograph seals and fixings before closing up, and hand over the schedule.
Send sizes, photos of any glass marks or your inspection report and we will come back with the right tested system.