Fire-Rated Glazed Screens
Internal glazed screens that keep compartments and corridors protected.
Learn more →Fire-rated escape route glazing in Rickmansworth is usually needed for one of three reasons: new building work, a change to an existing fire-resisting wall, or defects found in an inspection. We handle all three.
Tell us what you need. We reply with next steps and a guide price.
We supply and install glazed screens, doors and panels on escape routes in offices, flats, schools and healthcare buildings, working from the fire strategy so integrity and insulation are used in the right places, and smoke control is maintained.
Whether the building is in central Rickmansworth or the wider WD3, HA6 districts, we can survey and quote. We also cover Watford, Chalfont St Peter, Gerrards Cross. Rickmansworth is about 6 km from Watford, the largest town in our Hertfordshire coverage.
Doors on escape routes usually need smoke seals as well as fire resistance, so the smoke-control classification matters too.
Building guidance limits the amount and position of integrity-only glass on protected routes because people may need to pass close to it while fire is on the other side. Insulating glass removes most of those limits.
Corridor subdivision doors and double-swing doors normally need vision panels so people do not collide.
Building work in England is covered by the Building Regulations 2010, with fire safety guidance in Approved Document B and impact safety guidance for glazing in Approved Document K.
Once a building is in use, the Regulatory Reform (Fire Safety) Order 2005 requires the responsible person to maintain fire safety measures, including fire-resisting glazing. The Fire Safety (England) Regulations 2022 add duties for multi-occupied residential buildings, including fire door checks in buildings over 11 metres.
In higher-risk buildings, broadly 18 metres or seven storeys with two or more homes, the Building Safety Regulator is the building control authority. England is also phasing out BS 476 references from Approved Document B, with the remaining fire-resistance references due to go in September 2029.
If an existing frame in a Rickmansworth building has no traceable evidence, we say so and price the options rather than guess.
You receive the classification references, glass marks and installation photographs for your fire safety records.
After survey you get a fixed written quote for the agreed scope, so Rickmansworth budgets are not open-ended.
Fire-rated escape route glazing applies to many building types in Rickmansworth, including retail and leisure units and hotels.
Doors that subdivide corridors or swing both ways normally do, and the glass must be fire-rated to suit the door.
Yes, with phasing and temporary arrangements agreed with whoever is responsible for fire safety in the building.
Yes. We survey and install in Rickmansworth and across Hertfordshire, including the WD3 district and nearby Watford.
We can give a guide range from photos and sizes, including a clear photo of any marks on the glass. A fixed price follows a survey.
Internal glazed screens that keep compartments and corridors protected.
Learn more →Doorsets with large glazed panels, tested as complete units.
Learn more →EI 30 to EI 120 glass that blocks heat as well as flames.
Learn more →Surveys that identify what fire glazing you have and what needs fixing.
Learn more →Send drawings, a fire risk assessment action or photos of the glass marks.
We measure each opening in Rickmansworth and check what the existing frames can accept.
We set out the system, glass, evidence and programme, with a fixed price.
We install, photograph seals and fixings before closing up, and hand over the schedule.
Send sizes, photos of any glass marks or your inspection report and we will come back with the right tested system.