Fire-Rated Glazed Screens
Internal glazed screens that keep compartments and corridors protected.
Learn more →Our fire-rated escape route glazing service covers Edmonton and neighbouring areas such as Tottenham and Enfield, with every job built around a tested system.
Tell us what you need. We reply with next steps and a guide price.
Escape route glazing is fire-rated glass in the walls and doors of protected stairs, lobbies and corridors, the routes people rely on to leave a building safely. It has to hold back fire and smoke for the rated time, and on many routes it has to keep heat away from people passing it as well.
Our Greater London coverage takes in Edmonton (N18, N9, EN3, N21, N17, EN1) and the neighbouring towns of Tottenham, Enfield, Chingford. Edmonton sits within our Greater London coverage, alongside Tottenham.
Building guidance limits the amount and position of integrity-only glass on protected routes because people may need to pass close to it while fire is on the other side. Insulating glass removes most of those limits.
In England, blocks of flats over 11 metres need regular checks of communal fire doors, including glazed ones.
Doors on escape routes usually need smoke seals as well as fire resistance, so the smoke-control classification matters too.
Building work in England is covered by the Building Regulations 2010, with fire safety guidance in Approved Document B and impact safety guidance for glazing in Approved Document K.
Once a building is in use, the Regulatory Reform (Fire Safety) Order 2005 requires the responsible person to maintain fire safety measures, including fire-resisting glazing. The Fire Safety (England) Regulations 2022 add duties for multi-occupied residential buildings, including fire door checks in buildings over 11 metres.
In higher-risk buildings, broadly 18 metres or seven storeys with two or more homes, the Building Safety Regulator is the building control authority. England is also phasing out BS 476 references from Approved Document B, with the remaining fire-resistance references due to go in September 2029.
After survey you get a fixed written quote for the agreed scope, so Edmonton budgets are not open-ended.
We can phase work in Edmonton around residents, staff or pupils, with out-of-hours options.
Every quote in Edmonton identifies the tested system: frame, glass, beads, seals and fixings, within its pane-size limits.
Sector guides below cover blocks of flats, hotels and other buildings in Edmonton.
Doors that subdivide corridors or swing both ways normally do, and the glass must be fire-rated to suit the door.
Yes, if it is fire-rated to the required classification and, for integrity-only glass, within the limits building guidance sets for that position.
Building work in Edmonton follows the Building Regulations 2010 and Approved Document B, and occupied buildings are covered by the Regulatory Reform (Fire Safety) Order 2005.
Yes. We plan phasing, out-of-hours work and temporary protection so the building can stay in use where the fire strategy allows.
Internal glazed screens that keep compartments and corridors protected.
Learn more →Doorsets with large glazed panels, tested as complete units.
Learn more →EI 30 to EI 120 glass that blocks heat as well as flames.
Learn more →Surveys that identify what fire glazing you have and what needs fixing.
Learn more →Tell us the rating required, sizes and building type, or ask us to find out.
A survey in Edmonton confirms sizes, access, existing evidence and fixing conditions.
You receive a written quote naming the tested system and classification.
Installation to the system details, then a handover pack with photographs and evidence.
Send sizes, photos of any glass marks or your inspection report and we will come back with the right tested system.